The PC-20 heater was specifically
designed as a pest control tool. The heater operates on
low-pressure steam and delivers 210+°F, which is within the
optimal temperature range for overcoming heat-sinks (steel,
concrete & plastics) yet still allowing for full control on
building ramp-up temperatures. The unit is portable,
lightweight and explosion-proof designed to Class 2, Div 1 &
2, groups F & G, which allows for operation in most milling
and food preparation atmospheres.
Classification:
CSA & UL listed.
Voltage:
110V-1 Phase - 60 Hz.
Horse power:
1/2 HP – 1725 RPM
Full load amps:
8.8 amps
Frame:
# 56
Switch:
Hand on / off switch.
CSA / UL
Electrical:
CSA / UL male plug-in
receptacles to match existing plant receptacles.
CFM:
1650 cu. ft. / min
Air Velocity:
756 ft / min
Static pressure drop:
¾ “ W.C.
Core:
Four way - single pass
configuration, twenty-four rows per side (patented
core.)
Material:
Aluminum on copper
spiral fin tube. Wolverine Tube Inc. or equal.
Copper:
Plant Spec: SB75 -
C12200
Dimensions:
.625” O.D x .020” x
.020” Wall Thickness (copper tube)
Aluminum Fin:
10 fins / inch. 1.50”
fin O.D. - .625” I.D. Area per fin (1.463 ins.2)
Material:
Double wall aluminum
air flow tube ( 18 gauge)
Fan:
Die cast aluminum 4
blade
Fan housing:
Mild Steel (12 gauge)
Guards:
Chrome wire (OSHA)
Wheels Rear:
10” air filled rubber
pneumatic.
Wheels Front:
3” lockable solid
rubber castors.
Steam Trap:
Spirex-Sarco
Thermostatic Model FT14 – 4.5 or equal
Valves:
Screwed end - two
piece stainless steel ball valve (ASME B1.20.1) Zimco
Gauge &Valve Ltd. or equal.
PRV:
Set relief point – 104
kPa (15-psig) automatic reseat operation. Watts Regulator
Company or equal.
Steam Pressure:
Maximum pressure - 15
psi - (provided by plant)
Condensate Return:
155 lbs / hr @ 15 psig
104 kPa. steam delivery.
Heater
Output:
234,135 Btu / hr with
ambient entering start-up air temperature @ 75 ºF at
elevation 3450 ft.
Temperature Output:
204 ºF with 15-psig
steam supply.
Length:
72 inches
Width:
26 inches
Height:
32 inches
Weight:
210 lbs. approx
Note:
This piece of equipment was designed to be able to fit
through standard door frames and made in a portable
configuration for ease of movement throughout the plant
during the heat treatment process.
Surface Finish Coating
Epoxy Powder Coat
Tough industrial grade coatings for
long life of product.
